View Full Version : blade/color
jedipadawan777
11-08-2008, 10:19 PM
My saber lights up and works fine but for some reason the blade is very dim in comparison to the force fx lightsabers. I have a buckpuck, TCSS complete thick wall blade, a seoul p4 lux 3, colored discs (when i take the discs out its still dim), and a 1 inch blade holder. Someone told me that its because of the blade. Any advice?
Jay-gon Jinn
11-08-2008, 10:29 PM
Check the wiring to be sure there isn't a short. Also do you have a Lux III or a p4? They are two totally different leds.
FenderBender
11-08-2008, 11:27 PM
Time to roll some gift wrap.................
Novastar
11-09-2008, 01:28 AM
My saber lights up and works fine but for some reason the blade is very dim in comparison to the force fx lightsabers. I have a buckpuck, TCSS complete thick wall blade, a seoul p4 lux 3, colored discs (when i take the discs out its still dim), and a 1 inch blade holder. Someone told me that its because of the blade. Any advice?
<---- did not see the word "optics" in there anywhere.
I'm going with "optics not present" on this one.
Hasid Lafre
11-09-2008, 01:33 AM
Iam guessing hes using a corbin blade.
LeMoel
11-09-2008, 03:17 AM
remember also that if it is a seoul p4 with a puck then he would need a strong heatsink such as copper(tims) or theres a good chance it will over heat
jedipadawan777
11-09-2008, 07:24 AM
I have a 10 degree lens and lens holder.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.