PDA

View Full Version : Nerf Longshot with Blaster Core



vortextwist
07-17-2008, 07:41 PM
Well this is a little project for the blaster core I bought. I started this by cutting out the bi pod section and hacked up the side arm
gun to fit into the spot where the bi pod was and gutted the whole thing.
I got a little hasty and was showing the wife how it was comeing and I messed up my BC so
now It can't get repaired till september:sad::sad::sad:
http://i74.photobucket.com/albums/i259/vortextwist/Longshot%20Mod/Longshotmod002.jpg
http://i74.photobucket.com/albums/i259/vortextwist/Longshot%20Mod/Longshotmod003.jpg
It glued up pretty good.
I wanted to have the barrel light up, so while trying to figure that out I just happen to measure the od of the stock barrel
and it was 3/4 inch and I just happen to have a couple 3/4 inch blades with some ultra film. while fitting things I noticed
there was a really nice notch and a tcss heatsink fit perfect. I ended up getting a red/orange luxIII from tim and used a
little reflector I bought for mhs but was too small. well that was a perfect fit also.:D:D
http://i74.photobucket.com/albums/i259/vortextwist/Longshot%20Mod/barrellandledsetup.jpg
I got the trigger switch all setup and works pretty good.
http://i74.photobucket.com/albums/i259/vortextwist/Longshot%20Mod/Triggerswitchsetup.jpg
here's a little vid of just the light and trigger workings.
http://s74.photobucket.com/albums/i259/vortextwist/Longshot%20Mod/?action=view&current=longshotmodtriggerandlightsetup.flv
I still have to figure out where to put the PLI and if I want an animated led bar. Any Ideas?

Hasid Lafre
07-18-2008, 06:14 AM
Well sence your putting your speakers in the front gun the only place to really is where the old ****ing bolt was.

Which Iam thinking about puting my speakers where the old ****ing bolt thingy was and put the pli and all that in the front gun slide holes.