super.ken2001
06-01-2008, 08:34 PM
Newbie needs saber parts validation
Hi,
I am trying to assemble a double-sided saber. However, I am completely new to saber building and I don't know much about electronics :cry:. I have been reading the forums, but I'm still confused :confused:about what exact parts I need. I'd be fantastic if anyone can answer my questions so I can get my saber order asap.
1. What are "complete blades" like the "LED Corbin style Battle blade"? What is included in a complete blade set?
2. I also saw the "Luxeon 3w driver V2 (Momentary)". Is that a driver board for the LED? If I buy a driver board, would that be wired to where the resistor/BuckPuck would be otherwise? What functionality does it have? Would a SPST Momentary Guarded switch work with the driver (what's the difference bwteen a latching switch vs a momentary switch)?
4. Is a 4AAA battery holder going to fit in a MDS connector?
Finally, can anyone be so kind as to review my design & wish list and make sure that I have the right compatible parts, current, voltage, etc? Am I missing any screw?:confused:
http://www.thecustomsabershop.com/ViewWishlist.aspx?WishlistId=1626
http://www.super-ken.com/saber_design.jpg
Thanks a lot.
Ken L. ;)
Hi,
I am trying to assemble a double-sided saber. However, I am completely new to saber building and I don't know much about electronics :cry:. I have been reading the forums, but I'm still confused :confused:about what exact parts I need. I'd be fantastic if anyone can answer my questions so I can get my saber order asap.
1. What are "complete blades" like the "LED Corbin style Battle blade"? What is included in a complete blade set?
2. I also saw the "Luxeon 3w driver V2 (Momentary)". Is that a driver board for the LED? If I buy a driver board, would that be wired to where the resistor/BuckPuck would be otherwise? What functionality does it have? Would a SPST Momentary Guarded switch work with the driver (what's the difference bwteen a latching switch vs a momentary switch)?
4. Is a 4AAA battery holder going to fit in a MDS connector?
Finally, can anyone be so kind as to review my design & wish list and make sure that I have the right compatible parts, current, voltage, etc? Am I missing any screw?:confused:
http://www.thecustomsabershop.com/ViewWishlist.aspx?WishlistId=1626
http://www.super-ken.com/saber_design.jpg
Thanks a lot.
Ken L. ;)