Probably a silly question

[Vecna]

Guys,

As the title says, this is probably a really silly question, but do the sink tube as per here: http://www.thecustomsabershop.com/1-14-x-12-Chrome-sink-tube--P83.aspx fit snugly over MHS parts?
Reason Im asking this is because I want to make a custom shroud for my next hilt, where the shroud is almost the same length as the hilt

Thanks in advance

V

[Hasid Lafre]

short answere yes

[Draconis Magnus]

short answere yes

You sure about that? He's pointing to a 1.25" and he's asking if it goes over the MHS parts... I don't think so... I'm planning on building an MHS and it has 2 sink tube adapters one with the 1.25" inside the adapters and a 1.5" outside the adapters.

Vecna, you need a 1.5" to go over the MHS parts... not the 1.25".

[Vecna]

You sure about that? He's pointing to a 1.25" and he's asking if it goes over the MHS parts... I don't think so... I'm planning on building an MHS and it has 2 sink tube adapters one with the 1.25" inside the adapters and a 1.5" outside the adapters.

Vecna, you need a 1.5" to go over the MHS parts... not the 1.25".

Thanks Draconis
Dont want Tim to custom the shroud and then it not fit :(