Strydur
05-23-2008, 09:35 AM
Corbin's new driver is now on the site.
http://www.thecustomsabershop.com/images/driverv21.jpg
Good size reference pic..it doesnt quite fit all the way but I think it could with a little modification.
http://www.thecustomsabershop.com/images/driverv22.jpg
Old driver on left..new on right
http://www.thecustomsabershop.com/images/driverv23.jpg
New driver back side. That little white switch is a momentary switch. If you order a momentary setup board then this switch would act the same as the one you attach to the switch contacts. If you have the latching setup then it still just acts like a momentary switch and will only turn on the driver while the switch is held down. This could work nicely for using a thumbscrew to screw down through the hilt and push this switch on etc..
http://www.thecustomsabershop.com/images/driverv21.jpg
Good size reference pic..it doesnt quite fit all the way but I think it could with a little modification.
http://www.thecustomsabershop.com/images/driverv22.jpg
Old driver on left..new on right
http://www.thecustomsabershop.com/images/driverv23.jpg
New driver back side. That little white switch is a momentary switch. If you order a momentary setup board then this switch would act the same as the one you attach to the switch contacts. If you have the latching setup then it still just acts like a momentary switch and will only turn on the driver while the switch is held down. This could work nicely for using a thumbscrew to screw down through the hilt and push this switch on etc..