madhorizons
05-08-2008, 09:30 PM
First off...to any store staff reading this....thank you sooooo much for stocking the small heat sinks again...I was very happy to see those again.
What do you folks usually use for lining up the collimator/lens and the blade?
On my hilt, the blade is pretty snug, but the heat sink has just a little room which isn't allowing itself to center properly, or will that take care of itself once I tap & use set screws?
What do you folks usually use for lining up the collimator/lens and the blade?
On my hilt, the blade is pretty snug, but the heat sink has just a little room which isn't allowing itself to center properly, or will that take care of itself once I tap & use set screws?