PDA

View Full Version : Rewiring Yoda Guts????



Habbena
05-04-2008, 05:47 PM
Anyone know how to properly rewire the Yoda guts. I am going to use them for the MHS saber I am building, the clash senser isn't where it usually is (I have done several of Ultras DIY, but the wiring here is different). Does anyone have a tutorial on properly rewiring this so for an Lux 3 conversion

Any help would be great!

Kasri Deodene
05-05-2008, 01:46 AM
Actually did mine yesterday.

The outputs are exactly the same as a Anakin ROTS.

The clash sensor is at the bottom of the led strip, so snip it off just above the sensor then snip off the negatives (all the same colours as the Anakin ROTS). One of the others is the positive feed (just woken up and can't remember which it is at the moment, splice a wire for the led positive leaving the other connected to the sensor. Lastly connect the bundled negatives to the negative for the led.

I got mine wired wrong at first and used the wrong wire to the sensor, so the led only flashed on when i set the clash sensor off.

http://i81.photobucket.com/albums/j209/scoobydave96/yoda003-1.jpg

Think the above is correct, if not switch the 2 on the left.

Habbena
05-05-2008, 07:27 AM
Thanks Very Helpful.