View Full Version : dimensions
ArkaiHalon
05-01-2008, 08:07 AM
Does anybody happen to know the dimensions of this
http://www.thecustomsabershop.com/MR-FX-Obi-Wan-conversion-kit-P273.aspx
Er Dan Gill
05-01-2008, 06:32 PM
I happen to have one of those, my Obi is apart for upgrades, what dimensions do you need?
ArkaiHalon
05-02-2008, 05:38 AM
sweet
Length and OD. Mainly will it fit in a 1.25 inch sink tube, witha little wiggle room? The normal 1.25 inch bladeholder is a little to big on OD for what I need, and this one looks like it might do the trick.
Er Dan Gill
05-02-2008, 04:40 PM
It wont fit in a 1.25" sinktube (already tried) outside diameter is 1.23". Maybe if you had Tim machine the large area at the base down a bit, or are patient with sand paper :D
Length on it is 3.27" with out the heat sink installed, 4.05 with the heatsink, LED, and optics installed.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.