Protein5000
02-21-2006, 03:50 AM
I want to make a screw together hilt - it's been mentioned a bit in the store wish list and ovbiously the modular hilt system uses this -and was wondering how one would go about cutting threads in 2 pieces of steel pipe to make them screw together. I would go modular but I prefer stainless steel and to have control over length parts and such.
I'm going to contact my black smith but I was wondering if there were any requirements as far as tube thickness and such and if it is an expensive process.
Less talk, more action........
I'm going to contact my black smith but I was wondering if there were any requirements as far as tube thickness and such and if it is an expensive process.
Less talk, more action........