Corbons board inside 1.25" tube

[Dark Navel]

Will it fit in a 1.25" hilt? If not has anyone tries to shave the eges of the board to make it fit?

I think just as long as I don't sand a lead on the board it would be OK but I want to see if anyone else has done it.

[ArkaiHalon]

it has to be shaved to fit in the MHS, so i dont' think it's gonna fit in an 1.25 with out help.

[Dark Navel]

Wonderful:(

[vortextwist]

from what I remember shaving my bro's down, you can trim quite a bit. we stacked an corbin and mr board into the mhs, so you could very well do it.

[Do-Clo]

The inside of my hilts are 1.25 inches diameter and with a little sanding on the edges of the driver board it will fit fine.

[Dark Navel]

Thanks for the info Do..

By the way I'm a big fan of your work. I am working on a Dooku saber right now and hopefully when I'm done it will as respected as your work.

DN

[Hasid Lafre]

Yeah the corbin board only needed moderate sanding to fit shug inside mhs. But I think with as much sanding my bro did it will fit inside a 1.25 sinktube.

If i had a sinktube and was redoing my saber I would be abel to know for sure but iam pritty sure with how its sitting now it should fit.