PDA

View Full Version : Question on heatsink



Dax Lander
01-17-2008, 04:38 AM
Hi everyone!

I wanted to start ordering my LED but noticed that the Heatsink2 is out of stock. I was wondering if i could substitute it with the MHS LED Mount/Heatsink that is offered.
Mind you i have a hilt that is already made by Conceptprops, so i have no way of taking it apart other then removing the screw at the bottom of the hilt, which is how you would install the batttery. The Blade holder has a 1'' ID

Dark Helmet
01-22-2008, 08:10 PM
the mhs heatsink is 33 mm wide,so if the hilt can house this under the blade holder, your only problem is holding it in place. maybe a c clip can hold tight enough... also, concept does make led kits, they just don't seem to be available often.

drakeion2
02-04-2008, 05:23 PM
another way i use when out of heat sink is make one ,with a close 1 inch rod, treaded they sell at home depot for 12$ for 2 ft just cut in piece of 3inch each so it make me 8 of them that easy and inexpensif on top of that it will fit inside a tube of 1 inch id
i like to do that cause it cause me less & i use it for all kind of stuff with lux led