Kabraxxis
12-18-2007, 02:37 PM
Directly re-posted from FX-Sabers.com:
I was wondering if I could custom-order a few parts from the D.I.Y section for some sabers. Namely I have the LED's and instructions needed but require the conversion blade holders and retention screws alone. In particular I need a Mace, Obi-Wan and Darth maul and was hoping to pick up some "generic" or blank blade holders I could mill as needed for a Yoda conversion. I can't seem to find any local machinists who have 1.25 OD/1'' ID tubing =/. If anyone can help or has any ideas I'm open to suggestions!
I was wondering how much it might cost if I asked for just a blank 2 or 3'' blade holder that could house an LED, lens, col., and maybe even a TCCS heatsink? I'm not afraid to do a little cutting myself but I cannot find anywhere to pick up a blank tube of aluminum or copper with a 1.25 OD and 1'' ID.
I was wondering if I could custom-order a few parts from the D.I.Y section for some sabers. Namely I have the LED's and instructions needed but require the conversion blade holders and retention screws alone. In particular I need a Mace, Obi-Wan and Darth maul and was hoping to pick up some "generic" or blank blade holders I could mill as needed for a Yoda conversion. I can't seem to find any local machinists who have 1.25 OD/1'' ID tubing =/. If anyone can help or has any ideas I'm open to suggestions!
I was wondering how much it might cost if I asked for just a blank 2 or 3'' blade holder that could house an LED, lens, col., and maybe even a TCCS heatsink? I'm not afraid to do a little cutting myself but I cannot find anywhere to pick up a blank tube of aluminum or copper with a 1.25 OD and 1'' ID.