DarthVagues
12-10-2007, 04:22 PM
Hello folks! Been lurking a while, and am in the process of building my first LED saber. I am designing provision for a PLI into the hilt, but I need to know the EXACT spacing of the grommets in the PLI. The store says the overall length is "a little over 1 3/4 inches" but I need to know the hole spacing itself. If anybody has one of these and would take a quick measurement, I'd be much obliged... It might be a bit before I can actually order one and I'm at a point where I need to either put in a space for the thing or leave it out of the design altogether. I'd rather keep it in! :wink:
If this is the wrong area for this question, I'd appreciate it if a mod could move it to the correct forum. Thanks!
If this is the wrong area for this question, I'd appreciate it if a mod could move it to the correct forum. Thanks!