Tekka
11-09-2007, 08:10 AM
Hi, I just got a Cyan Lux3 and a Luke 2005 RotJ MR board and was wondering if i should use the MR board to power the LED or use a relay direct drive configuration? I am looking for the maximum brightness and running time.
Also how many batteries does the MR board and the LED need together? It read the original board uses 6AA but that is a bit too much i think and was wondering if i and get away with 4 NiMH 1.2V batteries? If i use 3 1.2v NiMH would i even need a resistor or should i stick with 4 batteries?
thx
Also how many batteries does the MR board and the LED need together? It read the original board uses 6AA but that is a bit too much i think and was wondering if i and get away with 4 NiMH 1.2V batteries? If i use 3 1.2v NiMH would i even need a resistor or should i stick with 4 batteries?
thx