PDA

View Full Version : First time builder,first time buying from here question



cyclonex65
11-02-2007, 07:31 PM
New to the whole site, so I'm not sure if this is right place for this topic, please forgive.

To start off, Hello, I'm CycloneX and I recently found this awesome site and shop and must say, keep it up! This is such a great source or knowledge and info on saber building. Now thats said.

Alright after exploring the site, and viewing and reading the tuts of the forums, I think I'm ready to order some parts and get started. Here is what I have come up with for my parts and pieces.

1- Screw on LED blade holder style 8
2- LED "Corbin style" Battle blade 1" OD
3- LED basic electronics kit - Lux III Red
4- Gender Changer
5- Double threaded hilt style 2
6- MHS ribbed extension
7- MPS Pommel style 3
8- MPS Insert style 1
9- Male battery connector
10- MHS Speaker mount
11- Premium Speaker

and waiting on these two cause they are out-of-stock
12- 4.8V AA 2600mAh NIMH Rechargeable battery pack
13- UltraSound

I read and looked at everything I could find and I thing that I got everything I need. My question to you Saber gurus is, Is there anything im leaving out that I will need to build this saber that I can order from here? Any suggestions?
Thanks

Lord Maul
11-02-2007, 09:13 PM
You need a C-Clip for the pommel :wink:

Jay-gon Jinn
11-02-2007, 10:35 PM
You could be waiting quite awhile on the Ultrasound, as well.

Hasid Lafre
11-02-2007, 10:41 PM
yep. I would find someone whos got an mr board for sale.

IMO I think the mr boards sound better than ultras.

cyclonex65
11-02-2007, 11:23 PM
Any good seller you know of for the MR board?

Lord Maul
11-02-2007, 11:47 PM
Get a broken MR off ebay. That is your best bet.

cyclonex65
11-03-2007, 09:29 PM
After reading some more info, I would need a screw for the chosen blade holder correct, and Tim to drill and tap it for me?

Tenric Starkindler
11-04-2007, 06:45 AM
covertech knob & screw.

sink tube (if you plan an overlay cutout)

cyclonex65
11-04-2007, 08:28 AM
The Covertech can be used as the screw for holding the blade in the blade holder correct?

vortextwist
11-04-2007, 09:07 AM
it can be but, your emitter would point up. normally the covertec would be at the pommel end.