PDA

View Full Version : set screw size question.



Hasid Lafre
10-23-2007, 05:23 PM
Ok so I got this old ultra style bladeholder(thanks again C) and iam trying to figure out what size setscrew I can fit in these holes that go around the bladeholder.

Now I can take this allen key I got and it fites in it and its kinda loose but not omg thats loose.

The number key is 5/64. Whats your thoughts? and what size tap would I need?

vortextwist
10-23-2007, 06:50 PM
just use a drill bit to see what size the hole is. geesh. you should know that. bring it by tomorrow.

Hasid Lafre
10-24-2007, 09:04 AM
you have it.

vortextwist
10-24-2007, 01:40 PM
i have the drill bit but not the tap. will have to see if work has one. we have the set screws also I beleive.