View Full Version : first mhs saber
jbarr
09-29-2007, 12:01 PM
i've been reading around the forums,but still have a couple questions. i have a ultrasound board,and alot of the hilt parts.i want to build a mhs with ultra sound,and a luxV cyan.since im using the ultra sound ,will i need a resistor?i know i need 7.2V to power this up,i saw 2 in the store a AAA 1000 mAh ,and AA 2600 mAh which will do?i've done 1 mr conversion,and will be doing another this week .i must say that after looking around this site a pics you have some very cool sabers !
xwingband
09-29-2007, 12:19 PM
If you can fit it use the 2600mAh one using AA's because you will get better runtimes.
No resistor. When you have driver no resistor is required.
Lord Maul
09-29-2007, 02:56 PM
A note of caution with the AA pack is that it barely fits into the 7 inch hilt section width-wise. Running wires past it is a pain.
Hasid Lafre
09-30-2007, 01:14 PM
My AA batery pack from the store fits just fine in my 7" section and wires can be ran anywhere.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.