PDA

View Full Version : OD of 1.25" bladeholders



Hasid Lafre
06-22-2007, 11:35 AM
What is the od of the 1.25 bladeholder?

Also if you took 2 of them and put them side by side what size pipe would one need to stick them both inside it?

vortextwist
06-22-2007, 11:52 AM
i think they are just under 1.25

Jay-gon Jinn
06-22-2007, 12:01 PM
You trying to make a double-barreled saber, Hasid??

Hasid Lafre
06-22-2007, 12:02 PM
Iam thinking about it but theres alot of other stuff I need to figure out like how iam gonna form the tubing around the bladeholders.

Novastar
06-23-2007, 04:44 PM
I was thinking about a double-barrel for one of the "blaster" props for BOP II... but the blasters just aren't used as much as I'd have hoped.

It shouldn't be too hard to couple two sabers together... also, Hasid, were you thinking to make them be able to "release" to be single sabers? And also, would they power on/off individually?