View Full Version : 1.25" sink tube

04-25-2007, 08:01 PM
If I wanted to build a saber using the 1.25" sink tube blade holder, which parts would I need? Could someone provide a quick tutorial?

Lord Maul
04-25-2007, 08:21 PM
read the thread index and FAQ threads before asking these questions please :wink:

04-25-2007, 10:27 PM
I've checked every tutorial, read through the faq and index, and searched the site, but I cannot find anything on how to install/use the 1.25" blade holder. :cry:

Perhaps I should have been more specific :oops: : Is the use/installation of the 1.25" holder any different than using a 1.5" sink tube with MHS adapter?

04-25-2007, 10:37 PM
Not really. It slides in and is screwed in place. Electronics wise it is the same as all of the other LED setups.

04-25-2007, 10:44 PM
Is the entire assembly inside the tube or could it be left partly sticking out. I think it might look cool because of the black color doubling as an emmiter, since you can't use an MHS emmiter on a 1.25". Or can you?

04-25-2007, 11:59 PM
You can leave it partly out yes.

04-26-2007, 08:07 PM
h4xyorj... you can see how one was mounted to a sink tube here:


It's as simple as it can get.

THANKS TIM, GREAT part! In my eyes, your best one yet!