Mech63
12-05-2019, 11:31 AM
Hello all
This is my first build so I have done a bunch of reading and have checked my work over multiple times. After I wired up the sound board it was time to test the SK6812 rgb strips. I tested each one separately and they worked great in all three fonts. I hooked them up together and got a few pixels on one strip working and now they both show no light at all. I am using a Spark3 sound board, Keep Power 15 amp high drain battery, 22 gauge wiring for everything except the speaker. I am also using 330 ohm resistor on the data line. The battery was freshly charged and is reading over 4 volts. I have read many posts in the string blade section but cannot find any answers to my dilemma. Anyone have some ideas on what to check?
This is my first build so I have done a bunch of reading and have checked my work over multiple times. After I wired up the sound board it was time to test the SK6812 rgb strips. I tested each one separately and they worked great in all three fonts. I hooked them up together and got a few pixels on one strip working and now they both show no light at all. I am using a Spark3 sound board, Keep Power 15 amp high drain battery, 22 gauge wiring for everything except the speaker. I am also using 330 ohm resistor on the data line. The battery was freshly charged and is reading over 4 volts. I have read many posts in the string blade section but cannot find any answers to my dilemma. Anyone have some ideas on what to check?