PDA

View Full Version : Neopixel strim Foam Diffuser



Aegean
05-27-2018, 11:25 AM
Hi everyone,

i'm working on a 7/8 neopixel blade and was wondering if anyone had any tricks to getting the foam diffuser up in the blade. I can get it about halfway and then it just starts getting stuck.

Thanks

Seth Skywalker
05-27-2018, 12:03 PM
You could try pinching the section you are about to put in, then twist and push slightly.

Squimboos
05-27-2018, 07:43 PM
Tie a string to the end and pull it through.. unless you've already got the tip glued in