Need some help here.

[Seth Skywalker]

Do any of you know how to remove this one?
16657
The other side.
16658
I was thinking I could try to pry it off but I don't want to risk breaking it. I really don't know how I should be able to remove it :eek:. Any help would be highly appreciated.

[Tom Tilmon]

they're expoxied on. try to gently pry and break each of the windings free from the back side of the plate, then tap the shaft out of the bearing. I have successfully freed a few of these. I used a very small flat head screwdriver to pry it off.

Tom

[Seth Skywalker]

I tried to tap out the shaft with a hammer but it didn't come out yet. What should I do?

[k6gad]

[QUOTE=Tom Tilmon;274506]they're expoxied on. try to gently pry and break each of the windings free from the back side of the plate, then tap the shaft out of the bearing. I have successfully freed a few of these. I used a very small flat head screwdriver to pry it off.

If it is epoxy... try heating the back with a flame from a lighter for a bit then pry gently from different sides. I have taken some of these off like that.

[k6gad]

I tried to tap out the shaft with a hammer but it didn't come out yet. What should I do?

The shaft and the armature need to go different directions at the same time... if you can push on the shaft and put a screw driver under each side of the armature it should pop off.

[PCModulus]

Pop the center out and then come in from the backside with a step drill on a press, youll know when its free. Thats the easiest way, prying will just snap the plastic on the stator.