Cloudfeather
12-18-2017, 04:01 PM
Ok, so I decided to build a neopixel blade, powered by the NBV4. The hilt will be a custom job by me, and I want the saber to be pretty streamlined overall. I've been doing a lot of research and here is my parts list so far...
Nano Biscotte Sound Module V4
18650 Single Cell Holder
MHS speaker mount V6 - For 28mm Speakers
2W 28mm Bass Speaker
Canadian TrustFire Protected 3.7V 2400mAh 18650 Lithium Battery (2-pack)
12mm Anti Vandal Momentary White Ring Switch
Pre-Soldered NeoPixel PCB connector and pin set
1" Thin walled Polycarbonate 40" long
TCSS Foam
Diffusion Film
Blade Cap
Various Resistors
Wire/Heat Shrink
The hilt will be various pieces of aluminum, either soldered or set screwed together.
I'm curious if anyone has a wiring diagram for a simple setup like this. I was reading through the NBV4 manual and found a lot of useful information, just want to cover all my bases.
It's my understanding that you can run this setup with the on AV switch, using it to toggle through the fonts and having a specific color set to each font through the SD card? And if anyone would happen to know what Ohm resistor I need inline with the AV switch, that would be helpful as well. Or any other constructive criticism. Thank you.
Nano Biscotte Sound Module V4
18650 Single Cell Holder
MHS speaker mount V6 - For 28mm Speakers
2W 28mm Bass Speaker
Canadian TrustFire Protected 3.7V 2400mAh 18650 Lithium Battery (2-pack)
12mm Anti Vandal Momentary White Ring Switch
Pre-Soldered NeoPixel PCB connector and pin set
1" Thin walled Polycarbonate 40" long
TCSS Foam
Diffusion Film
Blade Cap
Various Resistors
Wire/Heat Shrink
The hilt will be various pieces of aluminum, either soldered or set screwed together.
I'm curious if anyone has a wiring diagram for a simple setup like this. I was reading through the NBV4 manual and found a lot of useful information, just want to cover all my bases.
It's my understanding that you can run this setup with the on AV switch, using it to toggle through the fonts and having a specific color set to each font through the SD card? And if anyone would happen to know what Ohm resistor I need inline with the AV switch, that would be helpful as well. Or any other constructive criticism. Thank you.