PDA

View Full Version : Nano Biscotte 4 L3 pad



artisannm
11-25-2017, 08:06 PM
Hello, i have a simple question and am wondering if others have this issue as well on the NB4? I'm getting an always-on power flowing through the L3 pad even when the board is switched off. Battery is fully charged and at contacts, my meter is reading 4.11 v.
One meter lead is on the + post of the card, and the other is on the L3 pad itself.
General background: working with the NB4, using 3.7 3400 mah Li Ion battery from the shop, trying to utilize the NB4 color mixing features - requires all three die, (RGB).

thanks...

Also, on a side note, in reading the forums, it almost sounds like some are wiring the foc to the pex, (the L3 pad) which doesn't make sense because the foc controls are on L2?