Recharge port to deep?!

[The Yin]

Ok, I'm not sure how I went wrong, but after months of slowly building a saber for a friend I was finally ready to plug in and give it a final charge before calling it done.
Buuuuuut, the recharge port is to deep for the plug to reach!!
I have the recharge port mounted on the Acrylic Chassis Disc for Recharge Port (http://www.thecustomsabershop.com/Acrylic-Chassis-Disc-for-Recharge-Port-S8-P772.aspx) inside of a MHS Gear (http://www.thecustomsabershop.com/MHS-Gear-P395.aspx) and I'm using one of the longer kill key pieces for it.
Does anyone have a solution for this? Is there an adaport I can get that will have a longer 2.1mm barrel plug?

Much Thanks,
The Yin

[The Yin]

Ok, answering my own question. I just used a razor blade and cut back some of the plastic so the plug can fit.
Still, feel free to mention what methods or suggestions you guys have to address this issue.

[Greenie]

You could make the hole in the hilt bigger so that the moulded plastic of the 2.1mm plug fits