Schwizzle
10-30-2017, 06:04 AM
Greetings again. I've come to the unfortunate conclusion that to fit this board into my saber using the chassis I got from GOTH 3D, I have to file down the yellow component on the CF8 board that is next to the battery/recharge port power pads.
Has anyone else had to do this? I've started filing it as was mentioned on GOTH 3D's website (at my own risk) , but I am concerned how much of it I can remove.
I could bore out the inside of the hilt more I suppose, but would need to find someone with a lathe for that (might be able to do this). Any thoughts?
Has anyone else had to do this? I've started filing it as was mentioned on GOTH 3D's website (at my own risk) , but I am concerned how much of it I can remove.
I could bore out the inside of the hilt more I suppose, but would need to find someone with a lathe for that (might be able to do this). Any thoughts?