Wiring Diagram help

[GenericName]

I'm in the process of getting ready to make my first saber and have chosen to opt for an old Hasbro board out of a toy lightsaber I had lying around.
However I'm not sure if my wiring diagram(s) are right and was hoping that someone might be able to give me some feedback on them.

I have been referring to the following threads in order to make said diagrams:
http://forums.thecustomsabershop.com/showthread.php?9010-2001-Hasbro-Electronic-Count-Dooku-Lightsaber-schematic
http://forums.thecustomsabershop.com/showthread.php?10288-2010-Electronic-Lightsaber-w-DVD-Tutorial&highlight=dynaohm+resistor

Here are my diagrams:
15858
15857
15859

I am fairly new to this and am rather ill at the moment so I haven't been able to think completely straight to the point where I think I've completely left out the soundboards battery negative connection on one of the diagrams. [EDIT] Added another diagram to amend the one which didn't have the soundboard battery negative connection on.
Any help is appreciated :)

[BZWingZero]

Your first image is correct for how you should wire the board. When you go to wire it just check the legs on the recharge port and the transistor. Also, I can't tell you if that resistor is correct as it depends on the color of your LED. It is correct for a blue or royal blue cree.

[GenericName]

Thankyou for letting me know, yes my LED is a blue cree LED.
This might be a silly question but when you say to check the legs on the transistor what exactly do you mean?

[Silver Serpent]

He means to be extra careful that you wire them up correctly. It's easy to get your wires hooked up incorrectly the first time you're wiring these.