Creating a blade holder that slides over hilt.

[Jjschmitt120]

So I have a Saberforge Archon, and I am attempting to customize it by removing the top shroud, and would like to replace it to make it appear as if the TCSS blade holder 2 is the actual blade holder. The problem is that it's inner diameter is too small, and the Archon body is not threaded. Any recommendations on how to go about this?

[Silver Serpent]

You'll likely need access to a machine shop with tools like metalworking lathes if you want to thread and/or bore out your existing parts. If you have no experience with these tools, you'll want to find someone who does.

It would be easier to build a new saber from scratch out of all MHS parts.

[Jjschmitt120]

yeah I think im going to just start from scratch so that it's unique