Zero__
05-24-2017, 08:00 PM
Hi guys,
Hoping someone could check my wiring schematic real quick. I've included a picture!
I'm using the Pico Crumble. Trying to keep it real simple!
Main questions.
1. I am *assuming* that R G B is in this order on the pico crumble. The manual doesn't make it clear. My LED is not RGB, it's just a white cree. I bought the prebuilt module from CSS. If I wire up to Red and choose Red under the mode, it should dump full pwm/3.7V over it just like I want, right?
2. Any ideas on how to get so many connections to the positive terminal of my 18650? Thinking of just making a big medusa looking splitter, five jumper wires into one. That way I can plug in the switch, recharge port, and LED, the 18650 battery holder can plug in, and the last plug will go out to V+ on the sound board.
3. The recharge port is a weird one. I realized I just drew this picture a bit incorrect. The 18650 should go into one of the leads of the recharge port ONLY, and then the other side of the recharge port goes to sound board V+ and V-, and the momentary switch and the LED.
Thanks guys for any feedback!
15474
Hoping someone could check my wiring schematic real quick. I've included a picture!
I'm using the Pico Crumble. Trying to keep it real simple!
Main questions.
1. I am *assuming* that R G B is in this order on the pico crumble. The manual doesn't make it clear. My LED is not RGB, it's just a white cree. I bought the prebuilt module from CSS. If I wire up to Red and choose Red under the mode, it should dump full pwm/3.7V over it just like I want, right?
2. Any ideas on how to get so many connections to the positive terminal of my 18650? Thinking of just making a big medusa looking splitter, five jumper wires into one. That way I can plug in the switch, recharge port, and LED, the 18650 battery holder can plug in, and the last plug will go out to V+ on the sound board.
3. The recharge port is a weird one. I realized I just drew this picture a bit incorrect. The 18650 should go into one of the leads of the recharge port ONLY, and then the other side of the recharge port goes to sound board V+ and V-, and the momentary switch and the LED.
Thanks guys for any feedback!
15474