1st Build Parts list check.

[RMDphoto]

Hey all, so this will be my first DIY build and am a bit intimidated.

This is what I am going toward, a custom etched take on a dark side Satele Shan saber. (will end up doing two down the road)https://c1.staticflickr.com/5/4252/34611696971_ae7d5bf4d9_b.jpg
or
https://c1.staticflickr.com/5/4186/34743229325_acdc5e5fe2_b.jpg

Today I ordered the following(jumped on it since the NBv4 came in stock).

Nano Biscotte Sound Module V4

MHSV1 Blade Holder Style 22

Pommel style 3

Hilt Style 1 (7" Double female threaded connector)
Machine recessed 16mm AV switch hole DF7

16mm Anti Vandal Momentary Stainless Switch

This is just to get me the NBv4 and the saber body to start fabrication, powdercoating and etching.

In my wishlist for my next order I have the following:

Switchcraft 2.1mm Power Jack

Custom Tri-Cree LED
Red Cree Die
Red Cree Die
Deep Red Cree Die

MHS speaker mount V5 - For 28mm Speakers

Acrylic Chassis Disc for NB and 18500/18650 pack - S3 (Black)

Stainless 4-40 all thread

Stainless Steel 4-40 Hex nut - 6

Kill plug style 5 - Silver

Li-Ion 18650 3.7V 2600mAh PCB Protected Rechargeable Battery Module

18deg Tri-Rebel/Cree Star Lens

Star thermal tape pad - Tri LED

Chassis Disc style 2 with holes

2W 28mm Bass Speaker



Some things I am not sure if I need or where to find are a LED Lens Holder(couldnt find) and resisters for the LED if any are needed.

Is there anything I have planned wrong for or forgotten?? Thanks!

[RMDphoto]

Well, I found a resistance calculator and I added two 1.5Ohm 5w resistors to the wishlist along with a power extender to do flash on clash.

Would really appreciate someone looking everything over and verifying if I have everything right....Please!

[Warlock]

Depending on how you're wiring your LEDs you don't need the PEX. If you're wanting both Reds to be the main color and Deep Red to be your FoC you can use your L1 for both mains, and L2 for FoC just like the NBv3 did.

You may want some of the spacers for your Chassis to cover the 4-40 threaded rod between your discs

[RMDphoto]

Thank you much, thats exactly what I am wanting to do with the LED's