Just A Jedi
05-02-2017, 11:43 AM
Hi everyone,
I'm new here, but I've lurked for a little while. I'm also NOT at all handy (so I'm shooting for a more "ready made" hilt), so I apologize in advance if this is in the wrong spot on the forum, or has already been asked/answered etc. I wanted to see if any of you had knowledge/input on this, or if this is just a Tim question.
Is it possible to have a pre-threaded shroud made similar to the attached image? I've used dimensions similar to standard MHS parts. This piece is double female, but it could be male/female too.
Thanks.
15388
I'm new here, but I've lurked for a little while. I'm also NOT at all handy (so I'm shooting for a more "ready made" hilt), so I apologize in advance if this is in the wrong spot on the forum, or has already been asked/answered etc. I wanted to see if any of you had knowledge/input on this, or if this is just a Tim question.
Is it possible to have a pre-threaded shroud made similar to the attached image? I've used dimensions similar to standard MHS parts. This piece is double female, but it could be male/female too.
Thanks.
15388