neo_tao
04-12-2017, 05:57 PM
I recently did my first install. I used an NBv3 board. When I activate the saber, the leds do not light and tge only sound is a clicking with a whistle-like noise (one click for each button push). So far I have tested the tri-cree after wiring the leds. The battery has been charged through the recharge port. The illuminated a/v switch lights up when the kill key is removed from the port (no boot up sound). I have checked to make sure that the SD card has been fully inserted. Any suggestions would be greatly appreciated.
https://youtu.be/GG9Lz56Kheo
https://youtu.be/GG9Lz56Kheo