PDA

View Full Version : First Install of NBV3 (noob) HELP!!!!



fernferro
04-11-2017, 07:16 AM
15268


HELP!!!

LEDS
the setup is running an tricree XP-E2 (B,G,W) each led have is the positive(+) pad an resistor (1ohm , 2w) that are connected to the battery power (+) and also to the Led Positive(+) pad of the NBV3, the negative pads(-) (G and B) are going to the led negative(-) pad of the NBV3, the W negative pad(-) to the FoC pad of the NBV3.

BATTERY REMOVABLE and SWITCH
the battery power negative (-) is going to the switch and to the negative(-) power pad of the NBV3. my setup is with an removable battery (3.7 18650 3.000 mAh Trustfire brand)

Speakers
going to the speakers pad of the NBV3.

PROBLEM: when i turn on the switch it only runs the green led and it has phantom sounds. The FoC is running great. the blue led doesnt run. another thing, the resistor for the White Led that comes from the positive pad it burns like hell and sometimes i see some smoke from there.

Silver Serpent
04-11-2017, 07:28 AM
Your diagram looks fine. I'm thinking you may have some issues with your soldering work. If you could post pictures of your LED star and your NBv3, that would be very helpful.

Smoke is NEVER a good thing to see when your saber is on.