PDA

View Full Version : CF8 - Tangible Font Selection (TFS) - Connection



Anoril
04-05-2017, 03:30 AM
Hello!

I'm new to CF8 and I'm going to solder the resistor for TFS (tangible font selection) to the card... Actually, it's a simple push button to detect crystal presence, but for easier forum later search I used "resistor" term.

I read a lot of docs and compared a lot of images to my card and I'm still not sure WHERE to place the device pins:
- the first one is quite easy to find as a pad exists and is quite well identified in Erv's documentation;
- the second one, is harder to me to find: depending on the image there is a resistor at the supposed location, sometimes not.

Here is MY card. I placed markers to various locations I suppose I should solder the pin... Could an Expert confirm to me (and to others how are wandering) which one is the correct one? :)

15236
1. Obvious first pad
2. Left pad of the resistor?
3. Right pad of the resistor?
4. Bottom-left pin of the component?

Thanks for the help! :)

Anorr

Anoril
04-11-2017, 01:07 PM
Hi there!

Erv' replied to me: it's pad #3 on the picture.

See U all