Prizm V4 Accent LEDs

[DarthSneaky]

Ok, I have questions about wiring the accent LEDs on the Prizm V4 soundboard. The manual does not tell me how to do it. I know that the LED positive wires go to the numbered pads with holes and the negative wires go to the ground, but; Do the two pads next to each LED positive need to be bridged? How do I know if I need to add a resistor? What kind of wrapping wire should I use to make a bridge? Please help me.

15232

[jbkuma]

Do the two pads next to each LED positive need to be bridged?
If you are attaching an LED, yes. Either with solder or a resistor.


How do I know if I need to add a resistor?
Math. Ohm's Law, same as your main LED. (hint: you almost certainly need a resistor)


What kind of wrapping wire should I use to make a bridge?
Wrapping wire is a specific thing, it's a stiff wire that can be bent and holds its shape. It doesn't have to be wrapping wire, wrapping wire is just convenient for this purpose because it holds its shape.

Erv shows the various techniques this here:
https://www.youtube.com/watch?v=nJIJMfrbCQM