Master Raa-nek Tollen
03-31-2017, 09:43 AM
Hey guys. Wiring up my first sabers in a while and wanted to double-check resistance values. Trying to get 2 of these done in the next week, if possible.
Pico Crumble
Luxeon Tri Rebel R-G-RB
3.7V 18650
According to the instructions from Erv, the test was done with no resistance on B or G dies and a 1.8ohm on R.
According to the Luxeon data sheet for Rebel LEDs, I arrived at the following using the online LED resistance calculator:
RB vf=3.51, 1A (max); 1ohm, 2W
G vf=3.51, 1A (max); 1ohm, 2W
R vf=2.6, 700mA (max); 1.8ohm, 2W
To complicate matters, I believe I have a 1ohm, 2w currently hooked up to the RB die, but when I fire it up (with a full battery), swing sounds play continuously until it is turned off, so I suspect my resistance may be to blame.
Thanks in advance,
Jason
Pico Crumble
Luxeon Tri Rebel R-G-RB
3.7V 18650
According to the instructions from Erv, the test was done with no resistance on B or G dies and a 1.8ohm on R.
According to the Luxeon data sheet for Rebel LEDs, I arrived at the following using the online LED resistance calculator:
RB vf=3.51, 1A (max); 1ohm, 2W
G vf=3.51, 1A (max); 1ohm, 2W
R vf=2.6, 700mA (max); 1.8ohm, 2W
To complicate matters, I believe I have a 1ohm, 2w currently hooked up to the RB die, but when I fire it up (with a full battery), swing sounds play continuously until it is turned off, so I suspect my resistance may be to blame.
Thanks in advance,
Jason