erlomd1932
03-02-2017, 08:20 AM
Hello again! hope all is well!
I have problem with my NBV3
just got it in the mail yesterday and wired it up. (I've installed like 5 of these this year alone) so I'm pretty well versed on wiring these NBV3's up.
Im not getting anything when I remove the kill key...
The battery charges with the recharge port so I know that can't be the issue and none of the pads on the soundboard are touching
I did however notice that when I bridge the battery (-) to the "all else" (-) on the soundboard, then I do get activation...if I hold it there long enough (with the wire bridged) I can also ignite it and cycle through the sound fonts...otherwise if its not bridged it will not work.
any ideas?
RECAP...
With the recharge port prongs facing you (and the middle prong facing down) I have:
Right: Red Power Wire (+)
Bottom: Black Battery Wire (-)
Left: White sound card wire (-)
everything else on the soundboard is properly wired and soldered in its correct location
SD card has been re-formatted with original sound fonts and config files re-installed
will only boot up, ignite, light up, swing, clash and power down if there is a wire bridged from the (-) of the soundboard to the (-) of the battery
and the recharge port will recharge the battery when connected to the charger...
Im a little confused here...if you can shed some light on it...(a friend of mine is also running into the same issue)
Thanks
I have problem with my NBV3
just got it in the mail yesterday and wired it up. (I've installed like 5 of these this year alone) so I'm pretty well versed on wiring these NBV3's up.
Im not getting anything when I remove the kill key...
The battery charges with the recharge port so I know that can't be the issue and none of the pads on the soundboard are touching
I did however notice that when I bridge the battery (-) to the "all else" (-) on the soundboard, then I do get activation...if I hold it there long enough (with the wire bridged) I can also ignite it and cycle through the sound fonts...otherwise if its not bridged it will not work.
any ideas?
RECAP...
With the recharge port prongs facing you (and the middle prong facing down) I have:
Right: Red Power Wire (+)
Bottom: Black Battery Wire (-)
Left: White sound card wire (-)
everything else on the soundboard is properly wired and soldered in its correct location
SD card has been re-formatted with original sound fonts and config files re-installed
will only boot up, ignite, light up, swing, clash and power down if there is a wire bridged from the (-) of the soundboard to the (-) of the battery
and the recharge port will recharge the battery when connected to the charger...
Im a little confused here...if you can shed some light on it...(a friend of mine is also running into the same issue)
Thanks