Nano biscotte simple question

[LightsaberToothedTiger]

So I have to be honest. My rgb "reyflex" build was powered by a igniter 2 soundboard. Umm that being said the wiring looks very similar but I'm a little confused. Are you not supposed to attach multiple wires to a single pad on the nano biscotte? The general wiring diagram shows wires connected to other wires and I'm wondering are you supposed to strip a bit of the wire case off and solder/heat shrink the spot the same way you would for attaching a resistor?

[Cire Yeldarb]

Either way works, it's whatever you are more comfortable with.

[LightsaberToothedTiger]

Either way works, it's whatever you are more comfortable with.

Thank you so much, this is very good to know. Another way to save space if necessary.

[LightsaberToothedTiger]

I'm unsure about the set up for the wiring of FoC. Do the two identical die have to be wired in series or can they be wired separately to the (+) pad with their own resistor?

[Greenie]

They have to be wired in parallel each with their own resistor.

[LightsaberToothedTiger]

They have to be wired in parallel each with their own resistor.

Dope. So wire each positive pad of red and attach the resistor to each and then join the wires if desired/simplify things. Thanks dude!