LordBrutalos
11-15-2016, 03:53 PM
So, I purchased the Roque font.
Itīs awesome to say the least.
I did what I always do, since Iīm not packing a CF.
Selected the swings, clashes, power on/off that I wanted.
The volume was quite low on this font, so I decided to up the volume in Audacity, as I always do with fonts.
Now after a clash or swing, thereīs a clicking noise when returning to the hum.
I tried everything I could think of, but no luck.
If I just load the original volume on the font, it sounds fine.
Any ideas?
Btw, the board is a Nano Biscotte V3 with 28mm bass speaker from tcss.
Itīs awesome to say the least.
I did what I always do, since Iīm not packing a CF.
Selected the swings, clashes, power on/off that I wanted.
The volume was quite low on this font, so I decided to up the volume in Audacity, as I always do with fonts.
Now after a clash or swing, thereīs a clicking noise when returning to the hum.
I tried everything I could think of, but no luck.
If I just load the original volume on the font, it sounds fine.
Any ideas?
Btw, the board is a Nano Biscotte V3 with 28mm bass speaker from tcss.