View Full Version : Roque Sound Font, clicking noise?

11-15-2016, 03:53 PM
So, I purchased the Roque font.
Itīs awesome to say the least.

I did what I always do, since Iīm not packing a CF.
Selected the swings, clashes, power on/off that I wanted.

The volume was quite low on this font, so I decided to up the volume in Audacity, as I always do with fonts.
Now after a clash or swing, thereīs a clicking noise when returning to the hum.
I tried everything I could think of, but no luck.

If I just load the original volume on the font, it sounds fine.

Any ideas?

Btw, the board is a Nano Biscotte V3 with 28mm bass speaker from tcss.

11-15-2016, 05:12 PM
Sounds like the font is clipping when you run it through Audacity. Watch your peaks.

11-17-2016, 07:17 PM
Also when you save, clear the metadata.

11-24-2016, 03:24 PM
Thanks guys, will try again.
Good input! :)

11-24-2016, 04:34 PM
Whenever you change the volume of a sound file you risk altering a number of things. Perhaps the zero crossings at the beginning and end of each file get altered. I would check those too.