Lord Dragon Master 9000
11-02-2016, 08:08 PM
Would an M5 (which I think is an 8mm) tap fit an 8-32 blade retention screw? Also what would be the best drill bit?
If not, would this one work?: http://www.ebay.com.au/itm/Tap-and-Drill-Set-8-32-/262679543610?hash=item3d28ebbf3a:g:OeUAAOSwpLNYBXZ t
This is the blade retention screw I have: http://www.thecustomsabershop.com/8-32-x-38-Stainless-Steel-thumb-screw-P538.aspx
My local hardware store only has M5 and upwards, but I think I'll need an M4.
First time builder by the way, so sorry if it's a stupid question.
Any input would be appreciated.
If not, would this one work?: http://www.ebay.com.au/itm/Tap-and-Drill-Set-8-32-/262679543610?hash=item3d28ebbf3a:g:OeUAAOSwpLNYBXZ t
This is the blade retention screw I have: http://www.thecustomsabershop.com/8-32-x-38-Stainless-Steel-thumb-screw-P538.aspx
My local hardware store only has M5 and upwards, but I think I'll need an M4.
First time builder by the way, so sorry if it's a stupid question.
Any input would be appreciated.