can you guys check out my diagram

[Darth Ethan]

14500

can you guys tell me how this looks?

[jbkuma]

Checks out, just like they wrote it up in the manual.

[Darth Ethan]

so its okay to have 2 wires conected to 1 pad? cause in the manule diagram it looks like a wire branches of from another wire? likethey just attached a wire 2 a middle of another wire wich looks more difficult and impractical.

[Silver Serpent]

It's typically easier to attach a single wire to a pad, and do a splice further down. Both ways are correct, but it can be tricky for a novice to connect two wires to a single pad at the same time.

If you twist the ends of the two wires together and pretin them as a single unit, it isn't so hard to connect them to the pad.

[Darth Ethan]

okay thank you

[daaguilar]

Can also try to solder the second wire on the underside of the board. Should be a pad there, too.