PDA

View Full Version : R.I.C.E. Port and PRIZM V4 CARD


jsummit
10-07-2016, 10:10 AM
Hello All,

Has anyone had any trouble with getting the RICE port software going for their PRIZM V4 card? Any suggestions?
darth_chasm
10-07-2016, 10:21 AM
Try switching the tx and rx lines.
jsummit
10-07-2016, 04:55 PM
Yeah, did that problem solved!
jsummit
10-07-2016, 04:56 PM
The next issue I have is not being able to change my blade color in the software. When I move the channel slider nothing happens!
jsummit
10-07-2016, 06:01 PM
figured that out too. I downloaded the wrong RICE software ha! Just trying to troubleshoot why my crystal chamber LED isn't firing. I have the wiring just as the manual shows, but I may have the wrong resistors. I used ones that came with some 5mm solid color LEDs I bought and assumed they would work for each color anode on the 5mm RGB LED. Could this be the problem. What resistors should I be using for each color anode on the 5mm RGB LED?
jsummit
10-10-2016, 12:10 PM
Figured out this too. I just needed to make my common negative for the 5mm RGB LED into a positive to the battery to match the main LED.