old_luke
09-08-2016, 06:32 PM
Okay, I fully expect to get **** upon. I know full well that this is a silly question with probably an equally silly answer. But I'm stuck and don't know what to do. So here goes:
I'm about to wire my tri cree, and I get everything set up. Wire is in the helping hands, soldering iron is in my hand, both are pre tinned, we're good to go. Right? Apparently not. For some reason, I can't get the wire to join with the LED pad. The solder will join just fine with the wire, but not the pad. What's wrong with what I'm doing?
Also, here's a video of my feeble attempts. https://youtu.be/KkkCr7P7RnA
I'm about to wire my tri cree, and I get everything set up. Wire is in the helping hands, soldering iron is in my hand, both are pre tinned, we're good to go. Right? Apparently not. For some reason, I can't get the wire to join with the LED pad. The solder will join just fine with the wire, but not the pad. What's wrong with what I'm doing?
Also, here's a video of my feeble attempts. https://youtu.be/KkkCr7P7RnA