My prizm keeps repeating its boot sound

[alcadude]

My prizm keeps repeating its boot sound when I try clash or swing noises.I have triple checked the wiring and everything is fine.Please Help!!

[Cire Yeldarb]

The sounds like the battery is disconnecting from the board. Or it could just be low charge I suppose, have you fully charged it?

[alcadude]

It is fully charged.But i don't know if the battery is getting disconnected.I have it wrapped in a lot of electrical tape.

[FenixFire]

It is fully charged.But i don't know if the battery is getting disconnected.I have it wrapped in a lot of electrical tape.

Are you using a removable battery and a battery holder, or is the battery hard wired? If hard wired did you solder the wires to the battery or did you order one pre-wired or with solder tabs installed? Might want to switch out the dynaohms from your other post and see if that changes things as well.

[alcadude]

i am using lots of electrical tape to hold the wires connected to the battery.

[FenixFire]

i am using lots of electrical tape to hold the wires connected to the battery.

That's the problem. Electrical tape is insulation not an attachment method. You need to solder or at the very least conductive epoxy.

[Cire Yeldarb]

or just get the battery holder

[alcadude]

I cant find one.Does the store sell one? Because i checked and they didn't seem to have one.

[Cire Yeldarb]

What type of battery is it? 14500, 18650, etc?

[rlobrecht]

Check this page. http://www.thecustomsabershop.com/Holders--C36.aspx There's an 18650 holder. A 14500 is AA sized.

[alcadude]

thanks for the help