YAG (Yet Another Graflex) parts list

[Captriker]

Ok. I've been collecting parts and am in the home stretch. Or so I hope.

Here is what I already have:

Graflex 2.1 kit
Darth Ryo knight's chassis for Graflex 2.1
.88" heat sink
Tri-Cree LED module Blue Blue White
1000ma Buck Puck


What I think I need:
Recharge port: http://www.thecustomsabershop.com/Switchcraft-21mm-Power-Jack-P822.aspx
Battery: http://www.thecustomsabershop.com/Li-Ion-18650-37V-2600mAh-PCB-Protected-Rechargeable-Battery-Module-P672.aspx
Charger: http://www.thecustomsabershop.com/37V-Li-ion-smart-charger-with-21mm-plug-P890.aspx
Speaker: http://www.thecustomsabershop.com/2W-28mm-Bass-Speaker-P662.aspx

I want to have a Blue saber but I'm not sure if I'm selling myself short with the CF8. Is RGB better? I assumed the white was for FoC...

I plan to have the activation switch be the red button and using the small switches with the kit. Does that work well enough? Is there a Better switch setup?

Thanks!

[Generic Jedi]

You won't need the buckpuck with the Crystal Focus.

[sgcdialler]

As FJK is so fond of saying, more is not always better. RGB is the way to go if you want to have any blade color at your whim. But since you just want a blue blade, BBW is what you want. The two blue LEDs will be brighter than a single (of course), and the white-on-top FOC is a really nice look. Generic Jedi is also correct, the CF will drive your LEDs--no buckpuck necessary.

[Captriker]

Thanks!

So now I need to order the battery, charging port/charger and speaker.