phook15
06-01-2016, 05:57 PM
So I just wired up my saber using a blade builders board and as I'm sliding it through the sink tube the switch positive and negative keep contacting the sink tube turning it on and off. I'm also sure thet recharge port was contacting the metal sink tube. After that I tried touching the two switch wires but nothing happened. No sound, no lights. Is it fried?
UPDATE: I just poked around it with a multimeter and after using the battery function on the voltage plus and minus on the board, and then connecting the switch positive and negs it turned on. What a ****ing relief, I've sunk $400 into the saber. If any of you newbies are wiring your saber, make sure not to do what I did! Put electricial tape on the switch positive and negatives , and on the recharge port too.
UPDATE: I just poked around it with a multimeter and after using the battery function on the voltage plus and minus on the board, and then connecting the switch positive and negs it turned on. What a ****ing relief, I've sunk $400 into the saber. If any of you newbies are wiring your saber, make sure not to do what I did! Put electricial tape on the switch positive and negatives , and on the recharge port too.