Cree XP-E2 CopperNova Wiring Help

[azurite2]

I have the Cree XP-E2 CopperNova (RGB Nodes) and I need to wire it up to my Prizm Sound Module V4, but the manual shows a different light and I don't think I can do what it shows. I also have a 1.2ohm 3w resistor which needs to go on the red node and 2, .47ohm .5w resistors on green and blue. If you could use MS Paint or something on the picture to give me an idea of what to do, that would be great!
14023
Thank You,
Grayson M.

[darth_chasm]

I wont draw for you but I will explain.

The pads on the board are marked L1, L2, L3. You wire the individual led's negative to those pads like so L1, L2, L3 = R, G, B. Having it this way makes it easy to remember when you're tuning your settings. Then ALL of the led positives are wired to the positive pad on the board...same pad you wire positive power to. You can combine all the led positive leads before wiring to the positive pad to save some space if you like

The pads on the star sandwich their respective led as follows: +R- +G- +B-

[azurite2]

Thank you so much, this helped me out a lot!