seizethehonkuss
03-31-2016, 05:48 PM
Hey I posted this under my other thread but wasn't sure if it was getting seen or not. I wired up my crystal focus and got everything on there right as far as I know. I used a few different writing diagrams to check my work and it fires up and makes the ignition and deactivation sounds and all the aux sounds and sound selection files all seem to work. The swings and any of those sounds that are kicked in by motion. It didn't work from
When I first fired it up and not sure that I did something or not. I wasn't soldering anywhere near the motion sensor nor did solder anywhere other than power and leds and speakers. Any advice would be sweet thanks in advance
When I first fired it up and not sure that I did something or not. I wasn't soldering anywhere near the motion sensor nor did solder anywhere other than power and leds and speakers. Any advice would be sweet thanks in advance