vsutherland01
02-26-2016, 04:17 PM
My nano should be wired correctly. I triple checked the wiring and even re-soldered the pads.
I have a battery, speaker, and tri cree (no flash on clash) as well as one accent LED running off the 3.3V pad.
The board boots up just fine but when it goes to activate it skips the power on and goes straight to the hum and the LED doesn't light up. When I swing the board it hums and it clashes, weirdly enough the LEDs all activate during clashes. When I go to turn it off everything works as well, lights come back on before they turn off and the power off sound works.
What in the heck is happening? Any help will be appreciated.
I have a battery, speaker, and tri cree (no flash on clash) as well as one accent LED running off the 3.3V pad.
The board boots up just fine but when it goes to activate it skips the power on and goes straight to the hum and the LED doesn't light up. When I swing the board it hums and it clashes, weirdly enough the LEDs all activate during clashes. When I go to turn it off everything works as well, lights come back on before they turn off and the power off sound works.
What in the heck is happening? Any help will be appreciated.